1. The Candy Packaging Machine should be used in an environment where the temperature is -10 °C - 50 °C, the relative humidity is not more than 85%, there is no corrosive gas in the surrounding air, no dust, no explosion hazard.
2. Ensure that the vacuum pump works normally for the granule packing machine, and the vacuum pump motor is not allowed to reverse. Oil tea three-dimensional transparent film packaging machine should be checked frequently
Bit, the normal oil level is 1/2-3/4 of the oil window (cannot be exceeded). When there is moisture in the vacuum pump or the color of the oil turns black, the new oil should be replaced at this time.
3, the impurity filter should be frequently removed and washed (usually once every 1-2 months, such as packaging debris should shorten the cleaning time).
4. For 2-3 months of continuous operation, the rear cover 30 should be opened to add lubrication to the sliding parts and the switch bumps. The connection activities on the heating rods should be lubricated according to the usage.
5. Check the decompression, filtration and oil mist triplets 24 frequently to ensure oil mist (sewing machine oil) in the oil mist and oil cup, and no water in the filter cup.
6. The heating strip and the silicone strip should be kept clean and free from foreign matter, so as not to affect the quality of the seal.
7. On the heating rod, the two-layer adhesive under the heating sheet will be insulated, and should be replaced in time when there is damage, so as to avoid short circuit.
8. The user has self-prepared working air source and inflatable gas source. The working pressure of the Chocolate Packaging Machine has been set to 0.3 MPa, which is more suitable. Do not adjust too much without special circumstances.
9. The granule packing machine is not allowed to be placed and impacted during the handling process, and it cannot be carried over.
10. The granule packing machine must have a reliable grounding device when it is installed.
11. It is strictly forbidden to put your hand under the heating rod to prevent injury and immediately cut off the power in case of emergency.
12. When working, first ventilate and then energize. When the machine is shut down, first cut off the electricity and then cut off the gas.
